Teracube 2e Screen Repair Guide

These instructions are applicable for the display screen part that comes with the mid-frame assembly (any screens shipped after May 2022). Please post your queries below.

The process is pretty involved and can be tricky for new users. It is advisable to use a local repair technician for the process.

  1. Remove the battery cover and battery.
    New Project

  2. Peel up the information sticker.
    New Project(1)

  3. Unscrew all the screws on the upper and lower board covers.
    UnscrewCovers

  4. Remove the upper and lower board covers.
    RemoveCovers

  5. Heat the display (optional for easier repair). A heat gun can be used, or a heated plate with controllable temperature, for example, the heated bed of a 3D printer.

  6. Unseat the display ribbon cable and charging cable from the motherboard.
    UnseatRibbonCables

  7. Disconnect the antenna cable from the motherboard.
    DisconnectAntenna

  8. Remove the logic board and charging port.
    RemoveChargingPort

  9. Remove the speaker.
    RemoveSpeaker

  10. Remove the microphone cover.
    RemovevMicCover

  11. Unscrew all of the motherboard mounting screws.
    UnscrewMobo

  12. Unseat the flex cable for the buttons.
    UnseatButtons

  13. Disconnect the flex cables for the cameras.
    UnseatCameraCables

  14. Remove the vibration motor.
    RemoveVibrator

  15. Unplug the proximity sensor.
    UnplugProxSensor

  16. Remove the cameras.
    UnseatCameras

  17. Remove the front speaker.
    RemoveFrontSpeaker

  18. Remove the flex cable for the buttons from the frame.
    RemoveButtonRibbon

  19. Reassemble the phone in the reverse order on the new screen frame.